Making Iscsi Port Settings; Viewing A List Of Iscsi Trunks - Asus DS300j G2 Series User Manual

v ScSI P I
IewInG I ort nformatIon
To view information about a port:
1. Click the Device tab.
2. Click the iSCSI Management icon.
3. Click the Port tab.
4. Click the port you want, then click the View button.
Port information includes:
• Controller ID – ID of the RAID controller where the port is located
• Status – Enabled or disabled*
• Jumbo Frames – Enabled or disabled*
• Link Status – Up or down, active or inactive
• MAC Address – MAC address of the target port
• Max Supported Speed – Maximum speed supported (1 Gb/s)
• Current Speed – Current or actual speed of the target port
• Relative Portals – The portals corresponding to this target port
Items marked with an asterisk (*) are adjustable under "Making iSCSI Port Settings"
m ScSI P S
akInG I ort ettInGS
To make iSCSI port settings:
1. Click the Device tab.
2. Click the iSCSI Management icon.
3. Click the Port tab.
4. Click the port you want, then click the Settings button.
5. Make settings changes as required:
• Jumbo Frames – Check to enable jumbo frame support on this port. Uncheck to disable.
6. Click the Submit button.
113
v l ScSI t
IewInG a ISt of I runkS
A trunk is the aggregation of two or more iSCSI ports to increase bandwidth.
To view a list of trunks:
1. Click the Device tab.
2. Click the iSCSI Management icon.
3. Click the Trunk tab.
Trunk information includes:
• Trunk ID – ID number of the trunk
• Controller ID – ID of the RAID controller, 1 or 2
• Master Port – ID of the master port
• Slave Ports – IDs of the slave ports
• Failed Ports – IDs of any ports that are not working
• State – Optimal, Sub-Optimal, or Failed
Failed ports result in sub-optimal and failed trunks.
a ScSI t
DDInG I runkS
Ports must be enabled to add them to a trunk. ASUS DS300f G2 supports a maximum of eight trunks.
You cannot use an iSCSI port that has portals configured to it. See "Viewing a List of iSCSI Portals" and "Deleting
iSCSI Portals."
To add an iSCSI trunk:
1. Click the Device tab.
2. Click the iSCSI Management icon.
3. Click the Trunk tab.
4. Click the Create Trun k button.
5. Make your choices as required:
• Controller ID – ID of the RAID controller, 1 or 2
• Master Port number – ID of the master port
• Slave Port number – IDs the slave ports
DS300f G2 Series User Manual