Controller Enclosure; Eternus Dx60 S5; Figure 140 Front View Of A 2.5" Type Controller Enclosure (Eternus Dx60 S5); Figure 141 Front View Of A 3.5" Type Controller Enclosure (Eternus Dx60 S5) - Fujitsu ETERNUS DX S5 Series Design Manual

6. Hardware Configurations

Controller Enclosure

1
CM port (CM#0, CM#1)
This port is used to connect SVCs and CMs.
Controller Enclosure
This section explains the controller enclosure and the main components of the ETERNUS DX.

ETERNUS DX60 S5

•
• ETERNUS DX100 S5/DX200 S5
• ETERNUS DX500 S5/DX600 S5
ETERNUS DX900 S5
•
• Controller
• Component
ETERNUS DX60 S5
The ETERNUS DX60 S5 controller enclosure contains drives installed in the front, and controllers and power
supply units in the rear.
Two types of controller enclosures are available: a 2.5" type and a 3.5" type.
●
Front View
Figure 140
1 2
3
Figure 141
1 2
Slot#8
Slot#4
Slot#0
3
1
Operation panel
An operation panel has LEDs, a Power switch, and a FUNCTION button.
2
2.5" drive or 3.5" drive
(Refer to
3
Flange cover
Front View of a 2.5" Type Controller Enclosure (ETERNUS DX60 S5)
Front View of a 3.5" Type Controller Enclosure (ETERNUS DX60 S5)
Slot#9
Slot#5
Slot#1
"■ Drives" (page 265).)
Slot#10 Slot#11
Slot#6 Slot#7
Slot#2 Slot#3
246
3
3
Design Guide