Eternus Dx500 S5/Dx600 S5; Figure 148 Front View Of A Controller Enclosure (For The Eternus Dx500 S5/Dx600 S5, With A Front Cover); Figure 149 Front View Of A Controller Enclosure (For The Eternus Dx500 S5/Dx600 S5, Without A Front Cover) - Fujitsu ETERNUS DX S5 Series Design Manual

6. Hardware Configurations
Controller Enclosure

ETERNUS DX500 S5/DX600 S5

The ETERNUS DX500 S5/DX600 S5 controller enclosure contains an operation panel, battery units, PCIe Flash
Modules (PFMs), and drives installed in the front and controllers (CMs), host interfaces (CAs), and power supply
units in the rear.
●
Front View
Figure 148
1
1
Operation panel
An operation panel has LEDs, a Power switch, and setting change switches.
2
Front cover
Figure 149
Cover)
1
2.5" drive
(Refer to
2
2.5" drive / PCIe Flash Module
(Refer to
S5)" (page
3
Battery (BBU#0, BBU#1)
(Refer to
Front View of a Controller Enclosure (for the ETERNUS DX500 S5/DX600 S5, with a Front Cover)
Front View of a Controller Enclosure (for the ETERNUS DX500 S5/DX600 S5, without a Front
1
BBU#0
3
"■ Drives" (page 265).)
"■ Drives" (page 265) and
264))
"■ Battery (ETERNUS DX500 S5/DX600 S5/DX900 S5)" (page
2
3
"■ PCIe Flash Module (PFM) (ETERNUS DX500 S5/DX600 S5/DX900
252
2
BBU#1
264).)
Design Guide