Verifying Qos Configuration And Performance; Monitoring Performance-Blackdiamond 10K Switch Only; Displaying Qos Profile Information - Extreme Networks ExtremeWare XOS Guide Manual

NOTE
To ensure that you display the QoS information, you must use the detail variable.

Verifying QoS Configuration and Performance

You can display a variety of QoS measures using the CLI.
Monitoring Performance—BlackDiamond 10K Switch Only
NOTE
This command is not supported on the Aspen 8810 switch.
After you have created QoS policies that manage the traffic through the switch, you can use the QoS
monitor on the BlackDiamond 10K switch to determine whether the application performance meets
your expectations.
QoS features performance monitoring with a snapshot display of the monitored ports. To view switch
performance per port, use the following command:
show ports <port_list> qosmonitor {ingress | egress}
NOTE
You must specify ingress to view the ingress rate-shaping performance. By default, this command displays the egress
performance.

Displaying QoS Profile Information

You can also verify the QoS configuration in place.
Refer to "Verifying Physical and Logical Groupings" on page 216
displaying QoS information for each port.
Displaying QoS Profile Information on the Aspen 8810 Switch Only
To display QoS information on the Aspen 8810 switch, use the following command:
show qosprofile
Displayed information includes:
QoS profiles configured
●
Weight
●
Maximum buffer percent
●
ExtremeWare XOS 11.1 Concepts Guide
Verifying QoS Configuration and Performance
for additional information on
219