Hitachi XP P9500 User Manual page 175
Hitachi dynamic link manager software user guide for windows (6.6) (hit5201-96006, november 2011)
Hide thumbs
Also See for XP P9500:
- User manual (746 pages) ,
- User manual (574 pages) ,
- User manual (640 pages)
Table of Contents
Advertisement
Figure 4-1 Using the command to confirm that an LU has been added on
page 4-17
shows an example of using the command to confirm that an
LU has been added. For details about the HDLM GUI, see the HDLM GUI
Help.
Figure 4-1 Using the command to confirm that an LU has been
5
For the new LU, write a signature, create partitions, and then format it.
.
Note:
The PathID is determined by the system choosing the smallest,
available number that is not already in use for another path. For
example, when a path is deleted and then a new path is added, the
PathID for the added path might not be the same number as the
deleted PathID.
When MSCS is used
1
Add an LU.
.
2
Stop node B.
.
3
On node A, perform the steps shown in When MSCS is not used.
.
4
Stop node A, and then start node B.
.
5
On node B, perform the steps shown in When MSCS is not used.
.
When you create a partition, assign the same drive letter as the one
assigned for node A in step 3.
6
Stop node B, and then restart node A.
.
7
On node A, register the new LU in MSCS, and set it up.
.
8
Restart node B.
.
Hitachi Dynamic Link Manager User Guide (for Windows(R))
added
HDLM Operation
4-17
Advertisement
Table of Contents
