Hitachi XP P9500 User Manual page 100

¢
7 The program checks the MPIO driver version, and then installs the MPIO
.
driver. If a message appears asking you whether you want to install the
MPIO driver, make sure that no multi-path management software other
than HDLM is installed.
¢
¢
8 follow the procedure below:
.
¢
¢
9 Specify a license key file or enter a license key by following the
.
instructions shown in the messages that appear in the window.
¢
¢
3-34
The program checks whether HDLM has already been installed. If
HDLM 5.4 or earlier has been installed, the KAPL09129-E message will
appear. If this happens, carry out the procedure shown in
from HDLM 5.4 or Earlier to HDLM 5.5 or Later on page
HDLM 5.5 or later has been installed, the KAPL09173-W message will
appear. If this happens, carry out the procedure shown in
Installation or Re-installation of HDLM on page
does not appear, go to step 7.
If you are planning to perform an unattended installation, execute the
installhdlm utility.
At the command prompt, execute the following command:
drive-to-which-the-installation-DVD-is-inserted:\HDLM_Windows
\DLMTools\installhdlm -f installation-information-settings-
file
Specify n for the restart key in the installation-information settings
file.
This command checks whether HDLM has already been installed. If
HDLM 5.4 or earlier has been installed, the KAPL09129-E message will
appear. If this happens, carry out the procedure shown in
from HDLM 5.4 or Earlier to HDLM 5.5 or Later on page
HDLM 5.5 or later has been installed, the KAPL09183-E message will
appear, and then the upgrade installation or re-installation will be
performed.
After the installation is complete, go to step 14.
If multi-path management software other than HDLM is installed, click
the Cancel button to cancel the installation, uninstall the multi-path
management software, and then install HDLM.
If no multi-path management software other than HDLM is installed,
click the Next button to continue the installation.
The KAPL09127-W message will appear if the MPIO driver has already
been installed and the version does not match the version of the MPIO
driver about to be installed.
- Click the Next button to install the MPIO driver.
- Click the Cancel button to cancel the installation.
If no message appears, go to the next step.
If a license key file was saved in step 5, specify that license key file.
If a license key file is not being used, specify the license key directly.
Creating an HDLM Environment
Hitachi Dynamic Link Manager User Guide (for Windows(R))
Migrating
3-64. If
Upgrade
3-63. If a message
Migrating
3-64. If