Gbic Tab - HP StorageWorks 8B - FC Entry Switch User Manual

Encd Errs Outside Frames
C3 Frames Discarded
LIP Ins
LIP Outs
Last LIP Received
Frames Rejected
Frames Busied
Link Failure
Loss of Sync
Loss of Signal
Port Speed
Port Trunk

GBIC Tab

The GBIC tab provides information about the GBIC (Gigabit Interface Converter) for the HP
Brocade 2400/2800 and FC 6164 switches or the Small Form Factor Pluggable (SFP) for the FC
Entry Switch 8B, FC Switch 8B, and FC 16B installed in the selected port. The information
displayed depends on the type of GBIC installed. The GBIC tab is shown in Figure 5-3.
Note:
•
Standard GBIC
•
Serial ID GBIC
•
Smart Finisar GBIC All of the above information, plus GBIC active status.
If the port does not contain a GBIC, the following information displays: "Not a serial ID GBIC. No
GBIC info available."
Web Tools User's Guide
Number of frames with encoding errors outside frames.
Number of class 3 frames discarded.
Number of LIPs received.
Number of times loop initialized by FL_Port.
Last LIP received: AL_PD, AL_PS.
Number of F_RJTs sent.
Number of F_BSYs sent.
Number of times NOS received/sent.
Number of times loss of sync occurred.
Number of times loss of signal occurred.
Displays the speed of the port.
Displays whether Trunking is enabled or disabled.
In this guide references to GBIC represent Small Form Factor Pluggable units (SFP).
Module type (short wave, long wave, etc.).
Module type, plus extended information about capabilities, interfaces,
and manufacturer.
5
Port View
5-5