Removing A Memory Module - Lenovo ThinkServer TD200x Hardware Maintenance Manual

6. Install and lock the left-side cover (see Installing the left-side cover).
7. Reconnect the external cables and power cords; then, turn on the attached devices and turn on the
server.

Removing a memory module

1
DIMM
2
Retaining clip
To remove a dual inline memory module (DIMM), do the following:
1. Read the safety information that begins on page Safety information.
2. Turn off the server and peripheral devices, and disconnect the power cords and all external cables.
3. Turn the server on its side so that it is lying flat, with the cover facing up.
4. Unlock and remove the left-side cover (see Removing the left-side cover).
5. Remove the hot-swap power supply or power supplies from the power-supply cage (see Removing
a hot-swap power supply).
6. Rotate the power-supply cage to its open position (see Opening the power-supply cage).
7. Remove the air baffle (see Removing the air baffle).
8. Locate the DIMM connectors on the system board (see System-board internal connectors).
Attention: To avoid breaking the retaining clips or damaging the DIMM connectors, handle the clips
gently.
9. Move the DIMM retaining clips on the side of the DIMM connector to the open position by pressing
the retaining clips away from the center of the DIMM connector.
10. Using your fingers, lift the DIMM out of the DIMM connector.
11. If you are instructed to return the DIMM, follow all packaging instructions, and use any packaging
materials for shipping that are supplied to you.
.
Chapter 7 Installing optional devices and replacing customer replaceable units
199