Using The Boot Selection Menu Program - Lenovo ThinkServer TD200x Hardware Maintenance Manual

1
UEFI boot recovery jumper (JP6)
2
Clear CMOS jumper (JP1)
3
SW6 switch block
Attention: Before you change any switch settings or moving any jumpers, turn off the server; then,
disconnect all power cords and external cables. See the safety information that begins on page Safety
information. Do not change settings or move jumpers on any system-board switch or jumper blocks
that are not shown in this document.
While the server is turned off, move switch 2 of the switch block (SW6) to the On position to enable the
power-on password override. You can then start the Setup Utility and reset the power-on password. You
do not have to return the switch to the previous position.
The power-on password override jumper does not affect the administrator password.
Administrator password
An administrator password is intended to be used by a system administrator; it limits access to the full
Setup Utility menu. If an administrator password is set, you must type the administrator password for
access to the full Setup Utility menu. You can use any combination of up to seven characters (A - Z, a - z,
and 0 - 9) for the password.
Attention: If you set an administrator password and then forget it, there is no way to change, override,
or remove it. You must replace the system board.

Using the Boot Selection Menu program

The Boot Selection Menu is used to temporarily redefine the first startup device without changing boot
options or settings in the Setup Utility.
To use the Boot Selection Menu program, do the following:
Step 1. Turn off the server.
Step 2. Restart the server.
Step 3. Press F12 (Select Boot Device). If a bootable USB mass storage device is installed, a submenu
item (USB Key/Disk) is displayed.
244
ThinkServer TD200x Hardware Maintenance Manual