Completing The Installation; Connecting The Cables - Lenovo ThinkServer TD200x Hardware Maintenance Manual

Step 3. Press down on the retention modules; then, rotate the release lever toward the rear of the chassis
to secure the system board.
Step 4. Install any of the following components that you removed from the system board:
• Microprocessors and heat sinks (see Installing a microprocessor and heat sink).
• DIMMs (see Installing a memory module).
• Extender card (see Installing an extender card).
• Adapters (see Installing an adapter)
• Battery (see Installing the battery).
Step 5. Reconnect any cables to the system board that you disconnected during removal (see
System-board internal connectors and Internal cable routing and connectors).
Step 6. Install the fan-cage assembly (see Installing the fan-cage assembly).
Step 7. Install the air baffle (see Installing the air baffle).
Step 8. Return the power-supply cage to its closed position (see Closing the power-supply cage).
Step 9. Install the power supplies (see Installing a hot-swap power supply).
Step 10. Install and lock the left-side cover (see Installing the left-side cover).
Step 11. Reconnect the external cables and power cords; then, turn on the attached devices and turn on
the server.

Completing the installation

To complete the installation, do the following:
1. Insert the bezel hinges into the slots on the server chassis and close the bezel (Closing the bezel media
door and Closing the bezel).
2. Position the left-side cover over the server.
3. Place the bottom edge of the cover onto the bottom edge of the server.
4. Rotate the top edge of left-side cover toward the server; then, press down on the cover handle until it
clicks into place (Installing the left-side cover).
5. Rotate the bezel to its fully closed position.
6. Using the supplied key, lock the left-side cover and bezel.
7. Connect the cables and power cords. For more information, see Connecting the cables.

Connecting the cables

Notes:
1. Be sure to turn off the server before you connect any cables to or disconnect any cables from the
server or hot-plug adapter.
2. For additional cabling instructions, see the documentation that comes with the optional devices. It might
be easier for you to route any cables before you install certain optional devices.
3. Cable identifiers are printed on the cables that come with the server and optional devices. Use these
identifiers to connect the cables to the correct connectors. For example, the hard disk drive cables are
labeled "HDD option."
The following illustration shows the locations of the input and output connectors on the rear of the server.
.
Chapter 7 Installing optional devices and replacing customer replaceable units
219