Removing A Heat-Sink Retention Module - Lenovo ThinkServer TD200x Hardware Maintenance Manual

1
Microprocessor
2
0.02 mL of thermal grease
5. Use the thermal-grease syringe to place 9 uniformly spaced dots of 0.02 mL each on the top of the
microprocessor. The outermost dots must be within approximately 5 mm of the edge. This is to
ensure uniform distribution.
Note: 0.01 mL is one tick mark on the syringe. If the grease is properly applied, approximately half
(0.22 mL) of the grease will remain in the syringe.
6. Install the heat sink onto the microprocessor as described in Installing a microprocessor and heat sink.

Removing a heat-sink retention module

1
Alignment triangle
To remove a heat-sink retention module, complete the following steps:
1. Read the safety information that begins on page Safety information.
2. Turn off the server and all attached devices; then, disconnect all power cords and external cables.
.
Chapter 7 Installing optional devices and replacing customer replaceable units
213