Installing A Microprocessor Retention Module - Lenovo ThinkServer TD200x Hardware Maintenance Manual

Installing a microprocessor retention module

To install a microprocessor retention module, complete the following steps:
1. Orient the triangle-shaped indicator on one corner of the microprocessor retention module to the
corresponding alignment triangle on the system board; then, place the retention module on the system
board.
2. Using a T8 Torx screwdriver, install the four screws that secure the module to the system board.
3. Install the microprocessor and heat sink (see Installing a microprocessor and heat sink).
Attention: Make sure that you install each heat sink with its paired microprocessor.
4. Install the air baffle (see Installing the air baffle).
5. Return the power-supply cage to its closed position (see Closing the power-supply cage).
6. Install the power supplies (see Installing a hot-swap power supply).
7. Install and lock the left-side cover (see Installing the left-side cover).
8. Reconnect the external cables and power cords; then, turn on the attached devices and turn on the
server.
216
ThinkServer TD200x Hardware Maintenance Manual