Raid Controllers; Using The Lsi Configuration Utility Program - Lenovo ThinkServer TD200x Hardware Maintenance Manual
Hardware maintenance manual for td200x
Hide thumbs
Also See for ThinkServer TD200x:
- Hardware maintenance manual (304 pages) ,
- Installation and user manual (246 pages) ,
- Installations- und benutzerhandbuch (246 pages)
Table of Contents
Advertisement
Step 4.
Use the Up Arrow and Down Arrow keys to select an item from the Boot Selection Menu and
press Enter.
The next time the server starts, it returns to the startup sequence that is set in the Setup Utility.
RAID controllers
The following table lists the various utilities available to configure RAID controllers before an operating
system is installed.
Table 23. RAID utilities
RAID configuration utility
EasyStartup RAID
configuration utility
MegaRAID BIOS
Configuration Utility
(WebBIOS)
LSI Logic MPT Setup Utility
Using the LSI Configuration Utility program
Use the LSI Configuration Utility program to configure and manage redundant array of independent disks
(RAID) arrays. Be sure to use this program as described in this document.
• Use the LSI Configuration Utility program to perform the following tasks:
– Perform a low-level format on a hard disk drive
– Create an array of hard disk drives with or without a hot-spare drive
– Set protocol parameters on hard disk drives
Description
• For use with all
factory-supported RAID
controllers
• Automatically detects
hardware and lists
all supported RAID
configurations
• Configures one disk
array per controller
using all drives currently
attached to the controller
• Created a RAID response
file that can be used
to configure RAID
controllers on similarly
configured Lenovo
servers.
For:
• ServeRAID-MR10i
controller
• ServeRAID-MR10is
controller
• ServeRAID-MR10m
controller
For:
• ServeRAID-BR10i
controller
• ServeRAID-BR10ie
controller
Location
EasyStartup DVD
In system firmware. To
access:
• Use UEFI Setup Utility.
• Press Ctrl + H at the
WebBIOS prompt during
startup.
In system firmware. To
access:
• Use UEFI Setup Utility.
• Press Ctrl + C at the LSI
prompt during startup.
Chapter 9
Where to find more
information
"Using the
ThinkServerEasyStartup
DVD" on page 249
Using the WebBIOS utility
Using the LSI Configuration
Utility program
245
.
Configuring the server
Advertisement
Table of Contents
