Lenovo ThinkServer TD200x Hardware Maintenance Manual page 20

Table 1. Features and specifications
Microprocessor:
• Intel Xeon dual-core or quad-core
with integrated memory controller
and Quick Path Interconnect (QPI)
architecture
• Designed for LGA 1366 socket
• Scalable up to four cores
• 32 KB instruction cache, 32 KB
data cache, and 8 MB cache that
is shared among the cores
• Support for up to two
microprocessors, second
microprocessor with pluggable
VRM
• Support for Intel Extended Memory
64 Technology (EM64T)
Notes:
• Use the Setup Utility to determine
the type and speed of the
microprocessors.
• For a list of supported
microprocessors, see
http://www.lenovo.com/thinkserver
and click Options.
Memory:
• 16 DIMM connectors (eight per
microprocessor)
• Minimum: 2 GB DIMM per
microprocessor
• Maximum: 64 GB
• Type: Registered ECC DDR3 800,
1066, and 1333 MHz DIMMs only
• Sizes: 1 GB single-rank, 2 GB
single-rank or dual-rank, 4 GB
dual-rank (PC3-10600R-999)
12
ThinkServer TD200x Hardware Maintenance Manual
Power supply:
Notes: To upgrade to two 920-watt
hot-swap power supplies, install
the redundant power and cooling
option kit. Kit includes one hot-swap
920-watt power-supply and three
hot-swap fans.
• Standard: One 920-watt 110 V or
240 V ac input dual-rated power
supply
• Upgradeable to two 920-watt
hot-swap power supplies
Hot-swap fans:
• Three (standard)
• Upgradeable to six fans (for
redundant cooling)
Note: To upgrade to redundant
cooling, install the redundant power
and cooling option kit. Kit includes
one 920-watt hot-swap power-supply
and three hot-swap fans.
Size:
• Height: 440 mm (17.3 in.)
• Depth: 767 mm (30.2 in.)
• Width: 218 mm (8.6 in.)
• Weight: 20 kg (42 lb) to 34 kg (75
lb) depending upon configuration
Electrical input:
• Sine-wave input (50-60 Hz)
required
• Input voltage low range:
– Minimum: 100 V ac
– Maximum: 127 V ac
• Input voltage high range:
– Minimum: 0.60 kVA
– Maximum: 1.10 kVA
Notes:
1. Power consumption and heat
output vary depending on the
number and type of optional
features that are installed and
the power-management optional
features that are in use.
2. These levels were measured
in controlled acoustical
environments according to
the procedures that are specified
by the American National
Standards Institute (ANSI)
S12.10 and ISO 7779 and are
reported in accordance with ISO
9296. Actual sound-pressure
levels in a given location might
exceed the average stated values
because of room reflections
and other nearby noise sources.
The declared sound-power
levels indicate an upper limit,
below which a large number of
computers will operate.