Removing A 2.5-Inch Hot-Swap Hard Disk Drive - Lenovo ThinkServer TD200x Hardware Maintenance Manual

2. Connect the USB cable to the replacement USB cable and EasyLED panel:
a. Rotate the USB cable and EasyLED panel mounting bracket so that you are looking at the rear
of the bracket.
b. Squeeze the retaining clips on each side of the USB cable connector and align the key on the cable
connector with the notch on the mounting bracket.
c. Insert the connector into the mounting bracket; then, release the retaining clips.
3. Feed the EasyLED diagnostics cable into the server through the opening in the front of the server.
4. Position the bottom of the USB cable and EasyLED panel mounting bracket into the opening and rotate
the top of the bracket toward the server until it clicks into place.
5. Connect the EasyLED diagnostics cable to the system board. See System-board internal connectors
andInternal cable routing and connectors to locate the USB and EasyLED diagnostics connectors
on the system board.
6. Install the fan-cage assembly (see Installing the fan-cage assembly).
7. Install the air baffle (see Installing the air baffle).
8. Return the power-supply cage to its closed position (see Closing the power-supply cage).
9. Install the hot-swap power supply or power supplies (see Installing a hot-swap power supply).
10. Install the bezel (see Installing the bezel).
11. Install and lock the left-side cover (see Installing the left-side cover).
12. Reconnect the external cables and power cords; then, turn on the attached devices and turn on the
server.

Removing a 2.5-inch hot-swap hard disk drive

1
Filler panel
2
Hard disk drive assembly
.
Chapter 7 Installing optional devices and replacing customer replaceable units
187