Installing The Battery - Lenovo ThinkServer TD200x Hardware Maintenance Manual

7. Remove the battery:
a. Use one finger to push the battery horizontally out of its socket, pushing it away from the socket.
b. Lift and remove the battery from the socket.
8. Dispose of the battery as required by local ordinances or regulations.

Installing the battery

The following notes describe information that you must consider when you replace the battery in the server:
• You must replace the battery with a lithium battery of the same type from the same manufacturer.
• After you replace the battery, you must reconfigure the server and reset the system date and time.
• To avoid possible danger, read and follow the following safety statement.
Statement 2
CAUTION:
When replacing the lithium battery, use only the battery recommended by the manufacturer. If your
system has a module containing a lithium battery, replace it only with the same module type made by
the same manufacturer. The battery contains lithium and can explode if not properly used, handled, or
disposed of. Do not:
• Throw or immerse into water
• Heat to more than 100° C (212° F)
• Repair or disassemble
To install the replacement battery, do the following:
1. Follow any special handling and installation instructions that come with the replacement battery.
2. Insert the replacement battery
a. Hold the battery in a vertical orientation so that the smaller side is facing the socket.
b. Place the battery into its socket, and press the battery towards the socket until it clicks into place.
Make sure that the battery clip holds the battery securely.
168
ThinkServer TD200x Hardware Maintenance Manual
1
: