Installing The Rear Adapter Retention Bracket - Lenovo ThinkServer TD200x Hardware Maintenance Manual

To remove the rear adapter-retention bracket, do the following:
1. Read the safety information that begins on page Safety information.
2. Turn off the server and all attached devices; then, disconnect all power cords and external cables.
3. Unlock and remove the left-side cover (see "Removing the left-side cover" on page 152).
4. Remove all adapters and place the adapters on a static-protective surface (see "Removing an adapter"
on page 177).
Note: You might find it helpful to note where each adapter is installed before removing the adapters.
5. Open the rear adapter retention bracket.
6. Reconnect the external cables and power cords; then, turn on the attached devices and turn on the
server.
7. Press the rear adapter retention bracket and release the top hinge point; then, release the other hinge
point and remove the bracket from the chassis.
8. If you are instructed to return the rear adapter-retention bracket, follow all packaging instructions, and
use any packaging materials for shipping that are supplied to you.

Installing the rear adapter retention bracket

1
Rear adapter retention bracket
2
Hinge pins
To install the rear adapter retention bracket, do the following:
1. Insert the bottom hinge point on the rear adapter retention bracket into the matching hole in the chassis;
then, insert the top hinge point into the matching hole.
2. Install the adapters (see Installing an adapter).
3. Close the rear adapter retention bracket.
4. Install and lock the side cover (see Installing the left-side cover).
5. Reconnect the external cables and power cords; then, turn on the attached devices and turn on the
server.
176
ThinkServer TD200x Hardware Maintenance Manual