Direct Line Pickup-Idle Line (I8Ll) - Lucent Technologies PARTNER Advanced Communications System Release 1.0 Programming And Use Instructions

Direct Line Pickup—Idle Line (I8LL)
Description
This feature allows users to access a specific outside line (where LL is a line
number from 01–15) when the line is not in use. This feature is useful for
accessing a line that is not assigned to the phone.
Related Features
If a line is in use, users cannot access it with this feature (they hear busy
tone). For information about accessing a ringing or held call, or joining a
call in progress, see Direct Line Pickup—Active Line.
If Line Access Restriction (#302) is set to No Access or In Only for a line
assigned to an extension, a user at the restricted extension hears busy tone
if Direct Line Pickup is used to access that line to place a call.
Considerations
You can program a Direct Line Pickup—Idle Line button on a system phone to
pick up a line by pressing the button then dialing the two-digit line number.
Programming
(See Figure 2-3 in Chapter 2 for the location of special programming buttons
such as s
To program a Direct Line Pickup—Idle Line button:
f 0 0 s s c
1. Press
or 11.
2. Enter the number of the extension to be programmed with this feature.
3. Press a programmable button.
4. Press left
5. Program another button for this extension or exit programming mode.
Using
System Phone
1. If you want, lift the handset.
2. Press the programmed button and dial the two-digit line number (01–15) of the
idle line you want to access; or press
number.
If you did not lift the handset, the speaker comes on automatically.
Standard Phone
1. Lift the handset.
You hear intercom dial tone.
8
2. Dial
access.
and e on system phones.)
i 8
.
and the two-digit line number (01–15) of the idle line you want to
i 8
and the two-digit line
Direct Line Pickup—Idle Line (I8LL)
at extension 10
5-59