Moving To Another Network - HP Jetdirect 250M User Manual

Moving to Another Network

When moving an HP Jetdirect print server that is configured
with an IP address to a new network, make sure that the IP
address does not conflict with addresses on the new network.
You may change the IP address of the print server to one that
can be used on the new network, or erase the current IP
address and configure another address after you are installed
on the new network. See the secton on the
configuration
factory default settings.
If the current BOOTP server is not reachable, you may need to
locate a different BOOTP server and configure the printer to
this server.
If the print server was configured using BOOTP, DHCP or
RARP, edit the appropriate system files with updated settings.
If the IP address was manually set (for example, from the
printer control panel or Telnet), reconfigure IP parameters as
described in this chapter.
Back to: start of TCP/IP configuration
for instructions to reset the print server to
default