HP Jetdirect 250M User Manual page 124

raw-port:
Specifies additional ports for printing to TCP port 9100. Valid ports
are 3000 to 9000, which are application dependent.
TCP/IP Access Control
allow: netnum [mask]
Makes an entry into the host access list stored on the HP Jetdirect
print server. Each entry specifies a host or network of hosts that are
allowed to connect to the printer. The format is "allow: netnum
[mask]" where netnum is a network number or host IP address, and
mask is an address mask of bits applied to the network number and
host address to verify access. Up to 10 access list entries are allowed.
If there are no entries, all hosts are permitted access. For example,
allow: 192.0.0.0 255.0.0.0 allows hosts on network 192.
allow: 192.168.1.2 allows a single host. In this case, the default mask
255.255.255.255 is assumed and is not required.
allow: 0 This entry clears the host access list.
For additional information, see
TCP/IP Other Settings
syslog-config:
Enables or disables syslog server operation on the print server: 0
disables, 1 (default) enables.
syslog-svr:
The syslog server's IP address. It specifies the server that the HP
Jetdirect print server sends syslog messages to. For more
information, see TCP/IP
syslog-max:
Specifies the maximum number of syslog messages that can be sent
by the HP Jetdirect print server on a per-minute basis. This setting
allows administrators to control the log file size. The default is 10 per
minute. If it's set to zero, the number of syslog messages is not
restricted.
syslog-priority:
Controls the filtering of syslog messages sent to the syslog server.
The filter range is 0 to 8, with 0 being the most specific and 8 the
most general. Only messages that are lower than the filter level
specified (or higher in priority) are reported. The default is 8,
messages of all priorities are sent. If 0, all syslog messages are
disabled.
syslog-facility:
A code used to identify the source facility of a message (for example,
to identify the source of selected messages during troubleshooting).
By default, the HP Jetdirect print server uses LPR as the source
facility code, but local user values of local0 through local7 can be
used to isolate individual or groups of print servers.
slp-config:
Enables or disables the Service Location Protocol (SLP) operation on
the print server: 0 disables, 1 (default) enables.
Security Features.
Overview.