HP Jetdirect 250M User Manual page 149

DHCP
(Read-only parameter) DHCP T2 timeout, specifying the DHCP lease
Rebind
rebind time (seconds).
Time
SNMP Main Settings
snmp- Enables or disables SNMP operation on the print server. 0 disables, 1
config (default) enables SNMP.
Specifies a password that determines which SNMP GetRequests the
HP Jetdirect print server will respond to. This is optional.Specifies a
get- password for SNMP GetRequests sent to the HP Jetdirect print
community- server. This password is optional. If a user-specified get community
name name is set, the print server will respond to either a user-specified
community name or the factory-default. The community name must
be ASCII characters. The maximum length is 255 characters.
Specifies a password that determines which SNMP SetRequests
(control functions) the HP Jetdirect print server will respond to. The
set- community name of an incoming SNMP SetRequest must match the
community- print server's "set community name" for the print server to respond.
name SetRequests must come from hosts that are configured in the print
server's host access list. Community names must be ASCII
characters. The maximum length is 255 characters.
SNMP Traps
Configures the print server to send (on) or not send (off) SNMP
authentication traps. Authentication traps indicate that an SNMP
auth-trap
request was received, but the community name check failed. 0 is off,
1 (default) is on.
Enters a host IP address into the HP Jetdirect print server's SNMP
trap destination list. The command format is:
The default community name is 'public'; the default SNMP port
number is '162'. The port number cannot be specified without a
community name, otherwise the port number will become the
trap-dest
community name.
To delete the table, use 'trap-dest: 0'.
If the list is empty, the print server does not send SNMP traps. The
list may contain up to five entries. The default SNMP Trap
Destination List is empty. To receive SNMP traps, the systems listed
on the SNMP trap destination list must have a trap daemon to listen
to those traps.
IPX/SPX Settings
Enables or disables IPX/SPX protocol operation on the print server.
ipx-config 0 disables, 1 (default) enables. For example,
"ipx-config 0" will disable IPX/SPX operation.
A user-assigned alphanumeric name assigned to the print server (31
ipx-
characters maximum). By default, the name will be NPIxxxxxx,
unitname
where xxxxxx are the last six digits of the LAN hardware address.
trap-dest: ip-address [community name] [port number]