Move To Another Network (Ipv4); Use The Hp Embedded Web Server; Use The Printer Control Panel - HP Jetdirect 640n Administrator's Manual

NOTE: This procedure resets all TCP/IP parameters. Parameters for other subsystems such as
IPX/SPX or AppleTalk are not affected.
To reset all parameters to factory default values, see
on page 125.

Move to another network (IPv4)

When moving an HP Jetdirect print server that is configured with an IP address to a new network,
make sure that the IP address does not conflict with addresses on the new network. You might need
to change the IP address of the print server, or remove the current IP address and configure another
address after it is installed. See
instructions to reset the print server to factory default settings.
NOTE: If you use an HP Jetdirect wireless print server, this section assumes that a wireless
network connection is established.
Moving an HP Jetdirect wireless print server to another network requires a new wireless connection
to that network.
If the current BOOTP server is not reachable, you might configure the print server to use a different
BOOTP server.
If the print server was configured using BOOTP, DHCP, or RARP, update the appropriate system
files. If the IP address was manually set (from the printer control panel or Telnet), reconfigure IP
parameters as described in this chapter.

Use the HP Embedded Web Server

You can use the HP Embedded Web Server on the HP Jetdirect print server to configure or view IPv4
and IPv6 parameters. For more information, see
on page 63.

Use the printer control panel

HP Jetdirect EIO or embedded print servers provide a configuration menu that you can open from the
printer's control panel. Using this menu, you can enable or disable network protocols and set basic
network parameters.
NOTE: Control panel configuration support of specific IPv4/IPv6 and IPsec networking parameters
depends on the HP Jetdirect print server and printer.
For instructions about using the control panel for your printer, see your printer documentation.
When accessing the HP Jetdirect menu from the printer's control panel, some TCP/IP network
configuration parameters that you can set include the following (see
(V.45.xx.nn.xx) on page 179
●
IP host name
●
TCP/IPv4 settings
●
TCP/IPv6 settings
●
Other network protocols (IPX/SPX, AppleTalk, DLC/LLC)
ENWW
Troubleshoot the HP Jetdirect print server on page 125
HP Embedded Web Server (V.45.xx.nn.xx)
for additional parameters):
Troubleshoot the HP Jetdirect print server
HP Jetdirect control panel menus
Use the HP Embedded Web Server
for
61