HP Jetdirect 250M User Manual page 92

Syslog Maximum
Messages
Syslog Priority
Idle Timeout
TTL/SLP
System Contact
System Location
Specifies the maximum number of
syslog messages that can be sent by
the HP Jetdirect print server on a
per-minute basis. This setting allows
administrators to control the log file
size. The default is 10 per minute. If
set to zero, no maximum number is
defined.
Controls the filtering of syslog
messages that are sent to the syslog
server. The filter range is 0 to 8, with
0 being the most specific and 8 being
the most general. Only messages that
are lower than the filter level
specified (that is, higher in priority)
are reported. The default value is 8
which reports all syslog messages. A
value of zero effectively disables
syslog reporting.
Specifies the number of seconds that
an idle connection is allowed to
remain open. Up to 3600 seconds
can be set. 270 is the default value. If
set to 0, the timeout is disabled and
TCP/IP connections will remain
open until closed by the device at the
other end of the network (for
example, a workstation).
Specifies the IP multicast Time To
Live (TTL) discovery setting for
Service Location Protocol (SLP)
packets. The default value is 4 hops
(the number of routers from the
local network). The range is 1-15. If
set to -1, multicast capability is
disabled.
Identifies a person who is assigned
to administer or service this device.
This field may include a phone
number or similar information.
When configured, this parameter
will be displayed on the HP Jetdirect
Home page.
Specifies the physical location of the
device or related information. Only
printable ASCII characters are
allowed, up to 64 characters.
When configured, this parameter
will be displayed on the HP Jetdirect
Home page.