HP Jetdirect 250M User Manual page 262

09 Check the network connections. If the connections are intact, run the power-on self-test:
LAN ERROR- turn the printer off, then on again. If the error persists, replace the print server.
BABBLE
0A Check the network connections. If the connections are intact, run the power-on self-test:
LAN ERROR- turn the printer off, then on again. If the error persists, replace the print server.
NOSQE
0C There may be a problem with your network cabling or the print server. Check the cabling
LAN ERROR- and connectors on your Ethernet network. If you cannot find a problem with your network
RECEIVER OFF cabling, run the power-on self-test: remove and re-attach the power module connector on
the print server. If the error persists, there is a problem with the print server.
0D There may be a problem with your network cabling or the print server. Check the cabling
LAN ERROR- and connectors on your Ethernet network. If you cannot find a problem with your network
TRANSMITTER cabling, run the power-on self-test: remove and re-attach the power module connector on
OFF the print server. If the error persists, there is a problem with the print server.
0E Check the network connections. If the connections are intact, run the power-on self-test:
LAN ERROR- LOSS remove and re-attach the power module connector on the print server. If the error
OF CARRIER persists, replace the print server.
10 There may be a problem with your network cabling or the print server. Check the cabling
LAN ERROR- and connectors on your network. If you cannot find a problem with your network cabling,
UNDERFLOW run the power-on self-test: remove and re-attach the power module connector on the print
server. If the error persists, there is a problem with the print server.
11 There is a problem with your network cabling or external network configuration. Verify
LAN ERROR- operation of the hub or switch port.
RETRY FAULTS
12 With a 10Base-T or 100Base-TX port connected, Link Beat is not sensed. Check the
LAN ERROR- NO network cable, and verify that the concentrator or hub is providing Link Beat.
LINKBEAT
13 Reset or power cycle the print server to enable the new configuration values.
NETWORK
RECONFIG - MUST
REBOOT
The configuration information for the NetWare functions is not stored correctly on the
15
HP Jetdirect print server. Use the installation software, embedded web server, or other
CONFIGURATION
tools to reconfigure the print server. If this error persists, there may be a problem with the
ERROR
HP Jetdirect print server.
The HP Jetdirect print server has not been configured for NetWare. Use the installation
16 NOT
software, embedded web server, or other tools to configure the print server for NetWare
CONFIGURED
networks.