HP Jetdirect 250M User Manual page 148

An integer (1..3600) that specifies the number of seconds an idle
print data connection is allowed to remain open. For example, "idle-
idle-
timeout 120" assigns 120 seconds as the desired idle timeout value.
timeout
The default is 270 seconds. If set to 0, the connection will not
terminate and other hosts will not be able to make a connection.
An integer (1..3600) that specifies the number of seconds that your
Telnet or FTP session can be idle before it will be automatically
telnet- disconnected. The default is 900 seconds. 0 disables the timeout.
timeout CAUTION: Small values, such as 1-5, may effectively disable the use
of Telnet. A Telnet session may terminate before any changes can be
made.
Sets TCP/IP factory default settings. After a cold reset, power cycle
cold-reset the print server. Parameters for other subsystems, such as IPX/SPX
or AppleTalk, are not affected.
Enables or disables the print server's embedded web server. 0
disables, 1 (default) enables.
ews-config
For more information, see
Specifies the maximum segment size (MSS) that the HP Jetdirect
print server will advertise for use when communicating with local
subnets (Ethernet MSS=1460 bytes or more) or remote subnets
(MSS=536 bytes):
0: (default) All networks are assumed to be local (Ethernet
MSS=1460 bytes or more).
tcp-mss
1: Use MSS=1460 bytes (or more) for subnets, and MSS=536 bytes
for remote networks.
2: All networks are assumed to be remote (MSS=536 bytes), except
the local subnet.
MSS affects performance by helping to prevent IP Fragmentation
that may result in data retransmission.
Specifies the maximum segment life (MSL) in seconds. The range is
tcp-msl
5 - 120 seconds. The default is 15 seconds.
TCP/IP Diagnostics
Last Config
(Read-only parameter) The IP address of the system from which the
IP
HP Jetdirect print server's IP address was configured.
TCP Conns (Read-only parameter) The number of client TCP connections that
Refused are refused by the print server.
(Read-only parameter) The number of times that client systems were
TCP Access
denied access to the print server because there was no allowable
Denied
entry in the print server's host access list.
DHCP (Read-only parameter) DHCP IP address lease duration time
Lease Time (seconds).
DHCP
(Read-only parameter) DHCP T1 timeout, specifying the DHCP lease
Renew
renewal time (seconds).
Time
Using the Embedded Web Server.