HP Jetdirect 250M User Manual page 267
Hide thumbs
Also See for Jetdirect 250M:
- Brochure & specs (4 pages) ,
- Administrator's manual (303 pages) ,
- User manual (181 pages)
Table of Contents
Advertisement
4E
The TFTP configuration file specified too many trap destination list entries using the "trap-
CF ERR - TRAP
destination:" keyword.
LIST EXCEEDED
4F
The TFTP transfer of the configuration file from the host to the print server failed with the
TFTP REMOTE
remote host sending a TFTP ERROR packet to the print server.
ERROR
50
The TFTP transfer of the configuration file from the host to the print server failed with the
TFTP LOCAL
local print server encountering some form of inactivity timeout or excessive
ERROR
retransmissions situation.
51
The overall retrying of the TFTP transfer of the configuration file from the host to the print
TFTP RETRIES
server has exceeded a retry limit.
EXCEEDED
52
An error was detected in the BOOTP or DHCP reply that the print server received. The
BAD BOOTP/DHCP
reply either had insufficient data in the UDP datagram to contain the minimum
REPLY
BOOTP/DHCP header of 236 bytes, had an operation field that was not
BOOTPREPLY(0X02), had a header field that did not match the print servers hardware
address, or had a UDP source port that was not the BOOTP/DHCP server port (67/udp).
53
The tagsize in a vendor specific field in the BOOTP reply is either 0, or greater than the
BAD BOOTP TAG
remaining number of unprocessed bytes in the vendor specified area.
SIZE
54
The print server is currently in the process of obtaining its basic IP configuration
BOOTP/RARP IN
information through BOOTP/RARP.
PROGRESS
55
The print server is currently in the process of obtaining its basic IP configuration
BOOTP/DHCP IN
information through BOOTP/DHCP, and has not detected any errors.
PROGRESS
56
The print server received a negative acknowledgment message from the DHCP server in
DHCP NAK
response to a configuration request.
57
The print server had received IP parameters from a DHCP server, but communication with
UNABLE TO
the DHCP server has been lost. Check status of the DHCP server.
CONNECT DHCP
SVR
If an infinite lease was assigned, the print server will use the IP address of the most recent
DHCP server used, but operation may be degraded until a DHCP server responds.
58
The printer does not support AppleTalk or AppleTalk extensions.
POSTSCRIPT
MODE NOT
SELECTED
Advertisement
Table of Contents
Troubleshooting
