HP Jetdirect 250M User Manual page 230

Provides general print server status and identification information.
Message Description
Status Current state of the print server.
An error code and message
Model The model number of the HP print server (for example, J6035A).
Number
Hardware The 12-digit hexadecimal LAN hardware (MAC) address of the print server installed in or
Address attached to the printing device. This address is assigned by the manufacturer.
Firmware The firmware revision number of the print server currently installed in the printer. The format
Version is X.NN.NN, where X is a letter that depends on the HP print server model.
Port Select Specifies the LAN port on the print server that has been detected for use:
Port Config Identifies the link configuration of the RJ-45 LAN port on the print server:
Auto Identifies whether IEEE 802.3u Autonegotiation on the 10/100TX port is enabled (on) or
Negotiation disabled (off).
On: the print server will attempt to automatically configure itself onto the network at the proper
speed (10 or 100 Mbps) and mode (half or full duplex).
Manufacturing The manufacturing identification code for use by HP Customer Care personnel.
ID
Date Identifies the date of manufacture of the HP Jetdirect print server.
Manufactured
I/O Card Ready: the print server has successfully connected to the network and is
awaiting data.
I/O Card Initializing: the print server is initializing the network protocols. For more
information, see the status line for each protocol on the configuration page.
I/O Card Not Ready: there is a problem with the print server or its configuration.
are displayed if the print server is not ready.
None: the print server is not connected to the network.
RJ-45: the RJ-45 network port is connected.
10BASE-T HALF: 10 Mbps, half-duplex
10BASE-T FULL: 10 Mbps, full-duplex
100TX HALF: 100 Mbps, half-duplex
100TX FULL: 100 Mbps, full-duplex
Unknown: the print server is in an initialization state.
Disconnected: a network connection has not been detected. Check network cables.