HP Jetdirect 250M User Manual page 151

(Read-only parameter) The name of the AppleTalk network zone on
Zone
which the printer is located.
(Read-only parameter) AppleTalk phase 2 (P2) is preconfigured on
Phase
the HP Jetdirect print server.
(Read-only parameter) Indicates the current AppleTalk
configuration status.
READY: Indicates the HP Jetdirect print server is awaiting data.
Status DISABLED: Indicates that AppleTalk was manually disabled.
INITIALIZING: Indicates that the print server is registering the node
address or name. An additional status message may also be
displayed.
DLC/LLC Settings
Enables or disables DLC/LLC protocol operation on the print server.
dlc/llc-
0 disables, 1 (default) enables. For example, "dlc/llc-config 0" will
config
disable DLC/LLC operation.
Other Settings
(Web Scan Config) Enables or disables the Web Scan feature on the
scan-config print server when connected to a supported device. 0 disables, 1
(default) enables.
Specifies the number of seconds (1 - 3600) that an idle scan
scan-idle-
connection is allowed to remain open. 0 disables the timeout. The
timeout
default is 300 seconds.
scan-email- (Email Scan Config) Enable or disable the scan-to-email feature in
config the Web Scan server. 0 disables, 1 (default) enables.
(MFP config) Enable or disable print server support of the client
software provided with your multifunction or all-in-one peripheral.
MFP-config
0 (default) disables client software support (allows printing only).
1 enables client software support (allows printing and scanning).
Specifies the communication mode over the USB port on the HP
Jetdirect print server.
usb-mode
• Auto (default): Automatically negotiates and sets the the
highest communication mode possible for the attached
printer or device.
• MLC: (Multiple Logical Channels) An HP-proprietary
communication mode that allows multiple channels of
simultaneous print, scan and status communications.
• BIDIR: A standard connection that supports bi-
directional communications between the printer and
print server. The print server sends print data and
receives status from the printer.
• UNIDIR: A standard connection in which data is
transferred in one direction only (to the printer).