HP Jetdirect 250M User Manual page 112

Selected syslog parameters on the HP Jetdirect print server are
listed in HP Jetdirect Syslog
Table A.4 HP Jetdirect Syslog Parameters
Item
Syslog Server IP
address
Syslog Maximum
Messages
Syslog Priority
Syslog Facility
Parameters.
Description
IP address of a syslog server to
send syslog messages to. If zero
(0.0.0.0) or not specified, syslog
messages are disabled.
The number of syslog messages
that can be sent by the HP
Jetdirect print server on a per-
minute basis, from 0 to 1000. This
parameter helps to control the
syslog file size. The default is 10
messages per minute. If 0, the
number of syslog messages is not
restricted.
A method for filtering syslog
messages that are sent to the syslog
server. The range is 0 through 8,
with 0 the most specific and 8 the
most general. Only messages that
are lower than the specified filter
level (or higher in priority) are
reported. The default is 8,
messages of all priorities are sent.
If 0, all syslog messages are
disabled.
A code used to identify the source
facility of a message (for example,
to identify the source of selected
messages during troubleshooting).
By default, the HP Jetdirect print
server uses LPR as the source
facility code, but local user values
of local0 through local7 can be
used to isolate individual or groups
of print servers.