Remote Access Trunk Assignment - AT&T MERLIN LEGEND Release 2.0 Programming Summary Manual

System Features

Remote Access Trunk Assignment

Use this procedure to assign or remove the trunks used for Remote Access.
In addition, you can use this procedure to specify whether the Remote
Access feature is dedicated (always used for Remote Access) or shared
(used for Remote Access only when Night Service is activated).
Trunks used for dedicated Remote Access must not be assigned to ring into a
calling group or the QCC queue.
In the Hybrid/PBX mode, if a trunk assigned to ring into the QCC queue is also
used for shared Remote Access, perform this procedure before you perform
the "QCC Operator to Receive Calls" procedure.
Summary: Remote Access Trunk Assignment
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
System manager
All
Not required
Form 3a, incoming Trunks - Remote Access
Remote Access is not assigned
Dedicated, shared, no remote
Yes
No
Lines Trunks
Dial line/trunk no.
used
Enter
[F4] [F8] [F1]
Specify how trunk is used
[F5]
Remote Access Trunk Assignment
RemoteAccss Lines Trunks
Specify how trunk is
Enter
Exit Exit
Type line/trunk no.
[F10]
[F10]
[F5]
14-29