E&M Signal - AT&T MERLIN LEGEND Release 2.0 Programming Summary Manual

Tie Trunks
E&M Signal
Use this procedure to specify the type of tie trunk signal, as follows:
1S - tie trunks are connected through the local telephone company
1C - tie trunks are connected directly to a system using 1S signaling
5 - tie trunks are connected to a system using type 5 signaling
Summary: E&M Signal
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
System manager
All
Tie trunk idle
Form 3c, Incoming Trunks - Tie
1S
1S, 1C, 5
No
Yes
LinesTrunks
Dial trunk no.
Enter
Enter Exit
[F4] [F2] [F4]
Specify signaling type
TIE Lines E&M Signal
Specify signaling type
Exit
Type trunk no.
[F10] [F5]
[F10]
[F5]
6-5
E&M Signal