Facility Restriction Level - AT&T MERLIN LEGEND Release 2.0 Programming Summary Manual

Automatic Route Selection

Facility Restriction Level

Use this procedure to assign a Facility Restriction Level (FRL) to each route.
The FRL ranges from 0 (least restrictive) through 6 (most restrictive) and is
used to restrict user access to the route. The FRL assigned to telephones
and Remote Access users is opposite from the FRL assigned to routes, where
0 is the most and 6 is the least restrictive.
NOTE:
Pool routes must be programmed before you assign Facility Restriction
Levels.
Facility Restriction Levels are assigned to Tables 1 through 18. Table 17 is
the default toll table and Table 18 is the default local table.
Summary: Facility Restriction Level
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
System manager
Hybrid/PBX
Not required
Form 9b, Automatic Route Selection Tables
Form 9c, Automatic Route Selection Default and
Special Numbers Tables
3
0 - 6
No
No
Tables ARS
Dial table no. and pool route no.
restriction level
Enter
[F8] [F6] [F4] / [PgUp] and [F1]
table no. and pool route no.
restriction level
Sub A FRL/ More and Sub B FRL
Exit
[F10]
[F10] [F5]
Facility Restriction Level
Dial
Enter
Exit
Type
Type
[F5]
15-7