Network Service - AT&T MERLIN LEGEND Release 2.0 Programming Summary Manual

PRI Facilities

Network Service

Use this procedure to specify the type of outgoing service provided by each
B-channel group (Megacom WATS and 800, MultiQuest Service, ACCUNET
Switched Digital Service (SDS), or Software Defined Network (SDN).
MultiQuest or any other service not shown on the Network Service screen can
be indicated by entering the 5-digit binary code that represents the service in
the Network Facilities Information Element of ISDN PRI layer 3 signaling
protocol. The code for MultiQuest is 10000.
Summary: Network Service
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
8-6
Network Service
System manager
All
Not required
Form 3b, Incoming Trunks - DS1 Connectivity (100D
Module)
Not applicable
AT&T Toll, Local, Mist
No
No
LinesTrunks
NetworkServ
network Service
Exit
[F4] [F6] [F2]
[F10] Specify network service
[F5] [F5] [F5]
PRI B-ChannlGrp
Dial group no.
Enter
Enter Exit
[F3] Type group no.
[F5]
Specify
Exit Exit
[F10]