Copy Options For Lines/Trunks - AT&T MERLIN LEGEND Release 2.0 Programming Summary Manual

Lines and Trunks

Copy Options for Lines/Trunks

Use this procedure to copy options assigned to loop-start or ground-start
trunks, tie trunks, or DID trunks. Note that many of these options apply to
Hybrid/PBX systems only. The following information is copied for each type:
For loop-start or ground-start trunks (including those emulated on T1
facilities): toll type, signaling type, and pool assignment (Hybrid/PBX
only)
For tie trunks: direction, tie trunk type, E&M signal, dial mode, dial
tone, answer supervision time, disconnect time, and pool assignment
(Hybrid/PBX only)
DID trunks (Hybrid/PBX only): block assignment and disconnect time
To find out whether there is an optional feature assigned that you would like to
copy, use Inspct from the system programming console or [PgDn] on a PC.
NOTE:
You can copy options to a block of trunks only if they are all the same
type (loop-start, ground-start, tie trunks, or DID trunks). If you attempt to
copy assignments and a mismatch in type is found, information is copied
to that point only. You receive no error message.
If you are copying options to a block of lines/trunks, they must be
sequentially numbered.
If the block you are copying to includes an invalid trunk type, the copying
process stops at the invalid type. Only the trunks that were copied to before
the invalid type was found are copied successfully.
If you are copying assignments to a block of trunks and one of the trunks is in
use, you see the message Trunk Busy - Pls Wait on your display. The
copy for the rest of the trunks in the block is delayed until the busy trunk
becomes idle. If you exit without waiting for the copying to be completed, the
copying done up to that point is not canceled.
4 - 2 0
Copy Options for Lines/Trunks