Start And Stop Times For Subpatterns - AT&T MERLIN LEGEND Release 2.0 Programming Summary Manual

Automatic Route Selection

Start and Stop Times for Subpatterns

Use this procedure to specify the time of day when calls are routed using
Subpattern B routing information.
Subpatterns are used to provide two different routing patterns according to
the time of day. This allows you to take advantage of lower rates that may
apply to some or all lines or to change restrictions on some facilities during off
hours.
The stop time for Subpattern B is the start time for Subpattern A.
Enter times in 4-digit, 24-hour notation, using leading zeros as necessary.
Summary: Start and Stop Times for Subpatterns
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
System manager
Hybrid/PBX
Not required
Form 9b, Automatic Route Selection Tables
Form 9c, Automatic Route Selection Default and
Special Numbers Tables
No time is specified, thus all calls are routed
according to Subpattern A
0000 - 2359
No
No
Tables ARS
Drop
Enter
Dial table no.
Stop
time
Enter Exit
[F8] [F6] [F8]
[Alt] + [P] Type start time
Type table no.
time [F10] [F5]
Start and Stop Times for Subpatterns
Sub B Start
Dial Start time
Enter
Drop
Enter
Exit
Type table no.
[F10]
[F10] [Alt] + [P]
[F5]
Dial table no.
Sub B
Dial stop
[F10]
[F9]
Type stop
15-5