Direct Station Selector (Dss) Page Buttons - AT&T MERLIN LEGEND Release 2.0 Programming Summary Manual

System Renumbering
Direct Station Selector (DSS) Page
Buttons
Use this procedure to set the three Page buttons on the DSS to correspond to
the system numbering plan. This procedure assigns extension numbers to
DSS buttons. You cannot program individual buttons on a DSS; this is the
only method for programming DSS buttons.
If only one DSS is attached, each Page button assignment sets the console
for a range of 50 extension numbers. If two DSSs are attached, each Page
button assignment sets the console for a range of 100 extension numbers.
Page button assignment should be sequential (Page 1: 0-49, Page 2: 50-
99, Page 3: 100-149).
NOTE:
If two DSSs are attached, change the factory setting so that the difference
between extension numbers assigned to the range is at least 100. For
example, assign Page 1 to begin with extension 10, Page 2 to begin with
extension 110, and Page 3 to begin with extension 210.
Operator Park Zone codes must be included in the extension number range
specified for one of the page buttons.
CAUTION:
Select Exit on the console, [F5] on the PC, when you have finished
this procedure. If you press Home, extensions may remain in the
forced idle condition (the LED next to each DSS button is on), and
the system may have to be restarted.

Direct Station Selector (DSS) Page Buttons

2-9