AT&T MERLIN LEGEND Release 2.0 Programming Summary Manual page 45

Introduction
Programming Basics
To begin programming, do the following:
On the console:
On the PC:
In most cases, to exit
or [F5] . Exceptions are noted as part of a procedure.
Ordinarily you complete a procedure by pressing Enter ( [F10] ) to save the
information you have programmed. occasionally you press Exit ( [F5] ) and
go back to the previous screen.
If you are programming a group of sequentially numbered extensions or
trunks, you may have the option of pressing Next ( [F8] ) to save your entry
and automatically provide the number of the next extension or trunk in the
sequence, thus saving you a couple of steps.
When you have completed a procedure, pressing Exit ( [F5] ) takes you Up
one screen in the menu hierarchy.
In most cases, you will be at an intermediate step in the procedure you have
just completed. At that point, you can select one of the options shown on the
screen and continue programming, or you can press Exit again. This
usually takes you back to the System Programming menu. If not, you again
have the option of continuing to program from the current screen or pressing
Exit again.
In a few cases, pressing Exit brings you back to the System Programming
menu where you can select another option to program or exit from system
programming.
14
Programming Information
Select Menu
Sys Program
The System Programming menu is displayed.
Type SPM
The System Programming menu is displayed.
from a screen without making any changes, press Exit
Exit:
Press any key [F1] [F5] :