Terminal Equipment Identifier - AT&T MERLIN LEGEND Release 2.0 Programming Summary Manual

PRI Facilities

Terminal Equipment Identifier

Use this procedure to assign the link layer address of a piece of equipment
connected to each D-channel. Normally, only one piece is connected and the
system assumes that the Terminal Equipment Identifier (TEI) is 0.
CAUTION:
The value of the TEI rarely has to be changed.
Check with your authorized support representative before changing
this value.
Summary: Terminal Equipment Identifier
Programmable by
Mode
Idle Condition
Planning Form
Factory Setting
Valid Entries
Inspect
Copy Option
Console Procedure
PC Procedure
8-14
Terminal Equipment Identifier
System manager
All
Not required
Form 3b, Incoming Trunks – DS1 Connectivity (100D
Module)
0
0 - 6 3
No
No
LinesTrunks PRI
slot no.
Enter
Enter Exit
[F4] [F6] [F6]
[F10] [Alt] [P]
[F5] [F5] [F5]
Protocol
Drop Dial new ID no.
Exit Exit
[F2] Type slot no.
Type new ID no.
Dial
TEI
[F10]