Fcc Notification And Repair Information - AT&T MERLIN LEGEND Installation & Maintenance Manual

Customer Support Information
Le présent appareil numérique n'émet pas de bruits radioélectriques
dépassant les limites applicable aux appareils numériques de la classe A
prescrites dans le Règlement sur le brouillage radioélectrique édicté par le
ministère des Communications du Canada.

FCC Notification and Repair Information

This equipment is registered with the FCC in accordance with Part 68 of its
rules. In compliance with those rules, you are advised of the following:
Means of Connection. Connection of this equipment to the telephone
network shall be through a standard network interface jack: USOC
RJ11C, RJ14C, RJ21X. Connection to E&M tie trunks requires a USOC
RJ2GX. Connection to off-premises stations requires a USOC RJ11C or
RJ14C. Connection to 1.544 Mbs digital facilities must be through a
USOC RJ48C or RJ48X. Connection to DID requires a RJ11C, RJ14C or
RJ21X. These USOCs must be ordered from your telephone company.
This equipment may not be used with party lines or coin telephone lines.
Notification to the Telephone Companies. Before connecting this
equipment, you or your equipment supplier must notify your local
telephone company's business office of the following:
The telephone number(s) you will be using with this equipment.
The appropriate registration number and ringer equivalence number
(REN), which can be found on the back or bottom of the control unit
is as follows:
If this equipment is to be used as Key System, report the
following number AS593M-72914-KF-E and if the system
provides both manual and automatic selection of incoming/
outgoing access to the network, report AS593M-72682-MF-E.
The ringer equivalence number for both systems is 1.5A.
For tie-line connection, provide the telephone company the facility
interface code (FIC) of TL31M and the service order code (SOC)
9.0F.
For connection to off-premises stations, report the FIC OL13C and
SOC 9.0F.
If this equipment is to be connected to digital service (1.544 Mbs),
the FIC is 04DU9-B for D4 framing format or 04DU9-C for extended
framing format, and SOC 6.0P.
If this equipment is to be connected to DID facilities, the FIC is
02RV2-T, and the SOC is 9.0F.
The quantities and USOC numbers of the jacks required for each
jack provide the sequence in which lines are to be connected: the
type lines, the FIC, and REN by position when applicable.
xvi Customer Support Information