Remove The Existing Escalade Ata Raid Controller And Install The New Escalade Ata Raid Controller; Reboot The Machine; Figure 35. Installation Complete Notification - 3Ware 7000-2 - Escalade RAID Controller User Manual

3ware Escalade ATA RAID Controller User Guide

Figure 35. Installation Complete Notification

Remove the existing Escalade ATA RAID Controller and
install the new Escalade ATA RAID Controller
Refer to the Hardware Installation chapter.

Reboot the machine

1 If you choose to reconfigure your disk arrays, press Alt-3 to
bring up the Disk Array Configuration Utility.
2 If you reconfigure your disk arrays, partition and format any
new disk arrays or freed disks. To partition, run fdisk by select-
ing Run... from the Start menu and typing fdisk in the Run
window.
3 To format, restart the system again and log in. Select the device
with the right mouse button in the My Computer window and
select Format... from the popup menu.
4 After formatting, reboot the system again to avoid running an
incompatible DOS mode and low performance.
98 www.3ware.com