Rebuilding A Mirrored Disk Array; Figure 16. Maintain Disk Array Display - 3Ware 7000-2 - Escalade RAID Controller User Manual

array. If the verify array process determines that the mirrored drives
are not identical or the parity is not correct, the array is degraded
and the rebuild process is launched.
The array listed below can have its write cache state changed.
Verify checks the data integrity of a fault tolerant array.
Array Unit 2 - 2 drive Mirror
Port 2 - QUANTUM FIREBALLP LM30
Port 3 - QUANTUM FIREBALLP LM30
Array's Write Cache State:
Alt-F1 Help

Figure 16. Maintain Disk Array Display

Note:
after they are initialized. For RAID 1 and 10 arrays the
initial verify must first be done in 3DM, otherwise the
initialization will not be done.

Rebuilding a mirrored disk array

Escalade ATA RAID Controllers allow you to create fault tolerant
disk arrays by selecting a mirrored RAID 1 or RAID 10 array.
These disk arrays store identical data on two or more drives to pro-
tect against drive failure. If one or more of the drives of a mirrored
www.3ware.com
M a i n t a i n D i s k A r r a y
enabled
Verify Array:
no
OK
Previous/Next
Fault tolerant arrays can not be verified until
3ware Disk Array Configuration Utility
30.0GB
30.0GB
30.0GB
Cancel
Enter Change Value Esc Cancel
57