3Ware 7000-2 - Escalade RAID Controller User Manual page 179

AEN_VERIFY_FAILED
AEN_VERIFY_DONE
AEN_SECTOR_OVERWRITE
AEN_RBLD_SOURCE_ERROR
AEN_DRIVE_NOT_SUPPORTED
AEN_QUEUE_FULL
AEN 001h SOFT_RESET
The ATA RAID controller has detected a soft reset from the device
driver. Soft resets are normal at driver load and unload time. If the
ATA RAID controller fails to respond to the device driver within a
reasonable amount of time, the device driver may issue a soft reset
to the ATA RAID controller and retry the command packet.
AEN 002h AEN_DEGRADED_UNIT
An error has been encountered and the array is operating in
degraded (non-redundant) mode.The user should replace the bad
drive as soon as possible and initiate a rebuild.
AEN 003h AEN_CONTROLLER_ERROR
The ATA RAID controller has encountered an internal error. Please
contact 3ware customer support.
AEN 004h AEN_REBUILD_FAIL
The
ATA RAID controller
operation. This error can be caused by drive errors on either
the source or the destination of the rebuild. However, due to
ATA drives ability to reallocate sectors on write errors, the
www.3ware.com
Table 1: AEN Error Messages
Message
was unable to complete a rebuild
Troubleshooting
Value
02Ah
02Bh
02Ch
02Dh
030h
0FFh
179