Installing The Ata Raid Controller On Systems That Boot; From A Different Device; Create Disk Arrays; Install The 3Ware Driver - 3Ware 7000-2 - Escalade RAID Controller User Manual

Installing the ATA RAID controller on
systems that boot from a different device
Materials required:
• 3ware CD-ROM
(You will be required to create a 3ware Windows Driver Installa-
tion Diskette from the files located on the 3ware CD-ROM.
Please refer to the "Readme.txt" file on the 3ware CD-ROM for
directions.)

Create disk arrays

Refer to the 3ware Hardware Installation and 3ware Disk Array
Configuration Utility chapters.

Install the 3ware driver

As a Plug and Play device Windows 98/ME will recognize the
Escalade ATA RAID Controller and automatically bring up the
Add New Hardware Wizard, which will guide you in installing
the new 3ware driver (see Figure 28). When the Add New Hard-
ware Wizard screen appears continue to the Install/Upgrade 3ware
driver section. Perform the following steps only if this Wizard does
not appear on your screen or was cancelled for some reason:
1 Log in after Windows installation is complete and insert the
3ware Windows driver installation diskette.
2 From the Start menu, select Setting, then Control Panel.
3 Double click on Add New Hardware icon. When the Add New
Hardware wizard lists devices that need to be installed, select
the SCSI Controllers.
4 Continue to the Install/Upgrade 3ware driver section.
www.3ware.com
Windows® 98/ME Installation
89