Replacing An Existing Ata Raid Controller With A New Version Of The Controller; Upgrade The 3Ware Driver - 3Ware 7000-2 - Escalade RAID Controller User Manual

3ware Escalade ATA RAID Controller User Guide
Replacing an existing ATA RAID controller
with a new version of the controller
Caution:
RAID Controller) for the new version ATA RAID con-
troller before installing the controller. Your computer
system will not boot with the new version of the ATA
RAID controller unless the new version of the driver has
been installed first.
Note:
RAID Controller does not require reconfiguring the
drives connected to your controller and will not affect
data stored in your disk arrays for this and previous ver-
sions.

Upgrade the 3ware driver

1 Backup any critical data prior to upgrading the 3ware driver.
2 Backup the appropriate 3DM alarm log:
Windows: 3waenlog.dat
Linux: /var/log/3w-aenlog.txt
See "Upgrade the 3ware driver" on page 92 if you are using
Windows 98/ME and "Updating the 3ware driver" on page 109
if you are using Windows 2000/XP.
3 Log in to your system as system administrator.
4 Go to the Start menu, click on Settings and open the Control
Panel window.
5 From the Control Panel window, open SCSI Adapters.
6 Click on the Drivers tab in SCSI Adapters.
7 Select the current driver in the SCSI Adapters window, then
click on the Remove button (see Figure 24).
76
Install the correct driver (Escalade 7000 ATA
Upgrading to a new version of the Escalade ATA
www.3ware.com