Continue With Windows Nt 4.0 Installation; Install The Driver Using The Diskette; Partition Device 0 To Create A Boot Area - 3Ware 7000-2 - Escalade RAID Controller User Manual

Continue with Windows NT 4.0 installation

1 When Setup is Inspecting Your Computer Hardware Config-
uration is displayed, press F6 immediately.
2 You will see a Windows NT 4.0 Setup display.
3 Press S to specify that you will be installing an additional mass
storage device. On the display that follows, select Other and
press Enter.

Install the driver using the diskette

1 You will be asked to insert a diskette into the floppy drive and
press Enter.
2 Select the 3ware ATA RAID Controller from the display that
appears and press Enter again. Ensure the path to this driver is
correct in Copy manufacturer's files from: at the bottom of the
box. To do this, type A:\winnt
3 After the driver is loaded from the diskette, you will receive the
message "Setup has recognized the following mass storage
devices in your computer:" The list will contain the 3ware ATA
RAID Controller. If not, check the hardware and restart this
software installation. Otherwise, press Enter.

Partition device 0 to create a boot area

1 Follow the displayed instructions for Windows NT 4.0 installa-
tion as directed until the following message appears "The list
below shows existing partitions and spaces available for creating
partitions."
2 The partitions list should contain an entry for your Escalade
ATA RAID Controller that resembles the following: 4111 MB
Disk 0 at Id 0 on bus 0 on 3waregsm. If it does not include a
3ware entry, check your hardware and restart the software instal-
lation process.
3 Create a partition in the unpartitioned space of device 0 for
installing Windows NT 4.0. Keep in mind that the space avail-
www.3ware.com
Windows NT®4.0 Installation
71