Clear The Paper Jam In Areas 8, 11, 12, And 13 - Xerox 6100BD - Phaser Color Laser Printer Manual

7. Turn the green knob (located to the right of the lever) in the direction of the arrow on the knob. This
will move any jammed sheets of paper further along the paper path to where the sheets are more
accessible and easier to remove.
8. If paper is torn when it is being removed from area 9, or if the paper is difficult to remove, use the
pinch lever located further inside area 9. Paper may be caught in this area during two-sided
printing.
CAUTION: The following area of the printer may be HOT! Use caution when inserting your
hand.
a. Locate the green pinch lever directly behind area 9 (above the green knob and further
inside area 9).
b. Carefully reach your hand into the area, squeeze the edges of the pinch lever and lift it up.
c. Remove any paper from this area.
d. Return the green pinch lever to its original position. Make sure the pinch lever is latched
properly.
9. Raise the Transport to its original position and use the green lever to latch it in place.
10. Push the paper tray back into the machine.
11. Close the Right Door.

Clear the Paper Jam in Areas 8, 11, 12, and 13

NOTE: Even if paper is not visible, go through the sequence to clear the paper jam. Carefully inspect the
rollers for any debris or torn pieces of paper. When clearing misfeeds, make sure a full sheet of paper is
cleared and there are no pieces of paper left in the machine.
To clear area 8:
1. Open the Top Cover using the handle on the top, front of the machine above Paper Tray 1. The
cover rotates up with hinges located on the rear of the cover.
2. Remove all paper under the cover.
3. Close the Top Cover.
To clear area 11:
4. Open the left Finisher Door using the handle above Paper Tray 3.
5. Locate the green handle in the top left corner with an arrow pointing to the right. This is area 11.
DT6180 HandyBook
Solutions in Alphabetical Order
116