Xerox 6100BD - Phaser Color Laser Printer Manual page 78

5. On the upper right side of the opening, locate the label for area 19.
6. About 76 mm (3 inches) down from the label and all the way to the right of the opening you should
see three wires (red, orange and brown) leading to a black plastic block mounted on a metal
bracket. The plastic block, with small white letters on it, is the detector.
7. Clean the surface under the white letters with the folded piece of paper from Step 1.
8. On a horizontal line 254 mm (10 inches) left of the Q1227 detector, look under a 127 mm (5 inches)
long black metal bracket for a round bulb-like object about 10 mm (3/8 inches) in diameter. This is
the Q1227 Sensor and should be cleaned as well with a soft cloth.
Q1218 Rear Stack Height Sensor:
9. Stand in front of the stacker drawer. Along the right side of the area you exposed when you opened
the Finisher Top Cover, approximately 356 mm (14 inches) back from the front of the machine, look
for a yellow ground strap. The ground strap is bolted to the right hand side of the machine frame.
10. Carefully duck your head under the Finisher Top Cover so you can look into the Finisher, and the
area next to the ground strap.
CAUTION: If you are wearing a necklace you may want to tuck it in or remove it so it will not
DT6180 HandyBook
Solutions in Alphabetical Order
78