Clear The Paper Jams In Areas 7, 6, 5, 4, And 2 - Xerox 6100BD - Phaser Color Laser Printer Manual

Clear the Paper Jams in Areas 7, 6, 5, 4, and 2

NOTE: These areas should be cleared in the order given; from areas 7, 6, 5, 4, and then area 2.
To clear area 7:
1. Open the Processor Doors.
2. Just below the top of the machine, behind the left Processor Door, is a green handle with an arrow
pointing up and to the left. Lift up and hold the green handle in this position.
3. Below the green handle is a green knob. Rotate the knob to the left and remove any paper in this
area.
NOTE: If paper falls into the machine, and cannot be retrieved, a service call will need to be
placed. This happens occasionally, but not normally.
4. Lower the green handle. Make sure that the area 7 baffle is lowered and latched securely.
To clear area 6:
5. Locate and pull out the Fuser Module. Grasp the square gray handle with a horizontal green stripe
and rotate it out and up at the same time. The handle is located above and to the left of Paper Tray
1.
CAUTION: The Fuser is very hot!
6. Remove any paper in the Fuser area. Make sure to look at the bottom of the Fuser Module for any
trapped sheets of paper.
DT6180 HandyBook
Solutions in Alphabetical Order
123