Xerox 6100BD - Phaser Color Laser Printer Manual page 152

external Finishers.
NOTE: Only one external Finisher can be active at a time.
4. If there are no Finishers enabled and on-line, continue with steps 5-9. If there
is a Finisher enabled (denoted by a check mark in the Enable column to the
right of the Finisher name) that you do not wish to use and you need to
enable a different Finisher, perform steps 10-16.
5. Select the [Profile Setup] tab.
6. To on-line the Finisher you want to use, highlight the Finisher and select [On-
line]. An check mark will be displayed in the On-line column.
7. Select the [On-line Finishers] tab.
8. Highlight the Finisher you want to enable and select [Enable]. A check mark
will be displayed in the Enabled column.
9. Select [Close] in the lower, left corner of the Finishing window.
10. Highlight the Finisher that you do not want to use and select [Disable]. An X
will be displayed in the Enabled column when the Finisher is disabled.
11. Select the [Profile Setup] tab in the Finishing window.
12. Highlight the Finisher that you do not want to use and select [Off-line]. An X
will be displayed in the On-line column when the Finisher is off-line.
13. To on-line the Finisher you want to use, highlight the Finisher and select [On-
line]. A check mark will be displayed in the On-line column.
14. Select the [On-line Finishers] tab.
15. Highlight the Finisher you want to enable and select [Enable]. A check mark
will be displayed in the Enabled column.
16. Select [Close] in the lower, left corner of the Finishing window.
DT6180 HandyBook
Perform Printer Functions
152