Clear The Paper Jam In Areas 7, 6, And 5 - Xerox 6100BD - Phaser Color Laser Printer Manual

Clear the Paper Jam in Areas 7, 6, and 5

Clear Jams in order from areas 7, 6, and then area 5.
1. Open the Processor Doors using the handle above Paper Tray 1.
To clear area 7:
2. Just below the top of the machine, behind the left Processor Door, is a green handle with an arrow
pointing up and to the left. Lift up and hold the green handle in this position.
3. Below the green handle is a green knob. Rotate the knob to the left and remove any paper in this
area.
NOTE: If paper falls into the machine, and cannot be retrieved, a service call will need to be
placed. This happens occasionally but not normally.
4. Lower the green handle. Make sure that the area 7 baffle is lowered and latched securely.
To clear area 6:
5. Pull out the Fuser Assembly. Grasp the square gray handle with a horizontal green stripe and
rotate it out and up at the same time. The handle is located above and to the left of Paper Tray 1.
CAUTION: The Fuser is very hot!
6. Remove any paper in the Fuser area. Make sure to look at the bottom of the Fuser Assembly for
any trapped sheets of paper.
DT6180 HandyBook
Solutions in Alphabetical Order
113